This post comes from Fred Nelson, MD, an orthopaedic surgeon in the Department of Orthopedics at Henry Ford Hospital and a clinical associate professor at Wayne State Medical School. Some of Dr. Nelson’s tips go out weekly to more than 3,000 members of the Orthopaedic Research Society (ORS), and all are distributed to more than 30 orthopaedic residency programs. Those not sent to the ORS are periodically reposted in OrthoBuzz with the permission of Dr. Nelson.
Fracture fixation with a plate and screws has been around for a century—and so has the problem of screw loosening. Part of the cause of screw loosening seems to be toggling caused by radial forces arising from plate micromotion. Several decades ago, locked screws were designed to prevent loosening and provide better fixation, but screws still loosen.
Two tests can predict screw loosening associated with bone microfracture and absorption: axial pullout stress and toggling radial stress. Recent studies have investigated two hypotheses: radial stress is a predominant cause of screw loosening, and bone resorption is triggered by high radial stress.
Finite Element Analyses
A finite elemental model was used to replicate fixation of a tibial fracture with a 3-mm gap using either a dynamic compression plate (DCP) or locking compression plate (LCP).1 The model included contact with bone, tension on screw insertion, and the placement of two inner screws and one outer screw on either side of the fracture for an 8-hole plate. Axial loading, torsional loading, and bending were applied. Forces exceeding 55 megapascal (MPa) were considered adequate to cause microfracture, whether by radial or axial force. (For reference, 55 MPa is just about 8,000 pounds per square inch.)
The principal finding was that more bone was damaged by radial than by axial stress in both types of plates. Both plate types had more bone damaged by radial stress at the central two screws than at the two end screws for all bending models.
Radiographic Analyses
A separate study evaluated clinical radiographs of fixation for humeral, radial, ulnar, femoral, and tibial shaft fractures. Researchers looked for screw migration or bone absorption of ≥1 mm around the screw. Both DCPs and LCPs were reviewed.
Researchers found that the outer screws loosened only after the inner screws loosened. There were 3 cases of bone loss with no loosening, 17 cases of bone loss with screw displacement, and no cases of screw loosening without bone loss. This strongly suggests that bone loss must occur for loosening to take place and that the earliest screw loosening occurs closer to the facture site.
Taken together, these results imply that the use of larger inner screws and/or the use of a different angle of fixation might reduce bone absorption that leads to loosening. In addition, radial stress testing might be more important than axial testing. Still, LCPs remain superior at resisting axial loading and bending moments, while DCPs remain superior at resisting torsional loading of unstable fractures.
Reference
- Feng X, Lin G, Fang CX, Lu WW, Chen B, Leung FKL. Bone resorption triggered by high radial stress: The mechanism of screw loosening in plate fixation of long bone fractures. J Orthop Res. 2019 Jul;37(7):1498-1507. doi: 10.1002/jor.24286. Epub 2019 Apr 8 PMID: 30908687
