Tag Archive | load to failure

Placenta-Derived Cells Give Short-term Boost to Tendon Repair

From journal articles to nightly news segments, it’s hard to avoid the barrage of information related to the use of cell-based therapies for musculoskeletal problems. While these approaches may turn out to be enthusiasm outpacing science (see related OrthoBuzz post, “Stemming the Tide of Stem Cell Hype”), one reason for the excitement is rooted in a very simple fact: it is really hard to get many soft tissues to heal, especially in certain patient populations. Moreover, failure of initial repair usually leads to even more biologically inhospitable repair environments. This clinical challenge has led to the zealous investigation of various cell-based compounds to see which ones might assist native soft-tissue cells with the formidable task of quick healing.

In the July 3, 2019 issue of The Journal, Ma et al. investigate the potential for human placenta-derived cells to augment the healing of chemically induced patellar tendon ruptures in rats. The injected placental cells introduced a transitory inflammatory response that led to increased load to failure at the 2-week mark, compared to biomechanical results in control rat tendons injected with saline solution. However, the addition of placenta-derived cells did not increase tendon load to failure beyond 2 weeks, and at no time point were differences seen between the control and experimental groups in tendon strength, stiffness, collagen organization, or cellularity.

While the positive results of this study were short-lived, they are important nonetheless. The animal model used is well thought-out and reproducible, allowing an easy path for future investigators to compare and contrast these results. Placenta-derived cell populations are widely available, and the authors clearly explained how the cells were processed, preserved, and delivered. With the increasing incidence of acute and chronic tendon injuries, and with the results of studies using other cell types being equivocal at best, these findings from Ma et al. are noteworthy.

Marc Swiontkowski, MD
JBJS Editor-in-Chief

Electrocautery Damages Metal Hip Implants in 2 Ways

In the setting of revision total hip arthroplasty (THA), the use of electrocautery—and contact between the thermal device and retained components—cannot always be avoided. In the May 15, 2019 issue of The Journal of Bone & Joint Surgery, Sonntag et al. perform two implant-retrieval analyses and a separate in vitro investigation to determine what kinds of damage take place when electrocautery energy meets titanium femoral stems.

The components for retrieval analyses were removed from patients who experienced a fracture of the femoral stem or femoral neck after revision THA. The authors found superficial discoloration and melting marks on the retrieved components, and elemental analysis indicated that material had been transferred from the electrocautery tip. During in vitro testing of 6 titanium alloy femoral stems, the authors found that electrocautery surface damage reduced load-to-failure by up to 47% when compared to undamaged femoral neck specimens. Microscopic analysis revealed notable changes in metal microstructure in electrocautery-exposed components, whereby certain zones exhibited higher strength than others, which, the authors speculate, might result in lower overall fatigue resistance.

Both the retrieval and in vitro analyses showed that electrocautery damage to femoral implants, particularly in the anterolateral region at the base of the neck, reduced implant fatigue resistance. However, the authors say their results need to “be carefully interpreted,” because they are based on only 2 retrievals and a limited number of test specimens. Nevertheless, they conclude that “electrocautery device contact [with femoral implants] should be avoided and the use of conventional scalpels is recommended, where reasonable.”